1. All Products
  2. Fosroc Renderoc Plug 10kg
Public Pricelist

Fosroc Renderoc Plug 10kg

https://sab-gate.com/web/image/product.template/1176/image_1920?unique=a1e7313

is supplied as a ready to use blend of dry powders which requires only the site addition of clean water to produce a highly consistent, rapid setting mortar..

157.50 AED 157.5 AED 157.50 AED

150.00 AED

    This combination does not exist.

      Terms and Conditions
    Prices excluding delivery costs
            

    Delivery with in 3 days
    Fosroc Maintenance Waterplug

    Related Blogs

    Fosroc, Constructive Solutions

    TDS


    Renderoc Plug is supplied as a ready to use blend of dry powders which requires only the site addition of clean water to produce a highly consistent, rapid setting mortar which is easy to apply in many difficult conditions. 
    The material is based on a blend of cements, graded aggregates, special fillers and chemical additives which control the rate of set and minimise the risk of thermal cracking. 
    Renderoc Plug provides an initial set time of approximately one minute.

    For the rapid temporary patching and plugging of concrete segments, concrete and brick tunnel linings, sewage systems, below ground access chambers, pipes, basements, foundations and mines.

    Trowel apply or hand-knead the mixed mortar in place, ensuring maximum contact with the substrate before the material sets. 
    If being used to plug running water, Renderoc Plug should be used and held in place until the initial set is reached. Note the minimum applied thickness of Renderoc Plug should be 15 mm.

    Renderoc Plug should be added to clean water in the following proportions: 
    one part clean water: 3 parts Renderoc Plug (measured by volume). 
    Mix to a stiff consistency in a suitable mixing drum or bucket, using a trowel or gloved hand. 
    Due to the rapid set characteristics of the product, only prepare a quantity of mortar which can be placed within the prescribed set time.

    • Emergency water-stopping capability
    • Single component - only the addition of clean water is required
    • Excellent bond to the substrate
    • Low exotherm minimises thermal cracking
    • Pre-bagged formulation to overcome variations in site batching
    • Contains no chloride admixtures

    New Products

    Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.