Pidilite Dr.Fixit 113 Fastflex kit 24kg

Surface Preparation 

• Allow new concrete and masonry substrate to fully cure prior application. 
• All surfaces must be free from oil, grease, wax, dirt or any other form of foreign matter which might effect adhesion. 
• Spalled Concrete must be sound before applied. 
• Substrate should be reach a "Saturated Surface Dry" (SSD) condition (damp, without standing water)
  

Mixing

• Use Portland cement mechanical mixer at slow speed; add product powder part to liquid part in a clean container until a smooth and homogenous slurry mixture is achieved. 
• Allow the mixed slurry to stand for 5-10 minutes for releasing air-trapped during the mixing prior to application.
• Mixing material must be use within recommend pot life. 

Applications

• Dr. Fixit Fastflex slurry can be applied by brush or roller. DO NOT dilute with water. 
• Recommend Coverage rate is approximately 1.1 kg./m2/coat for 1 mm. (Minimum 2 coat.). 
• Allow the slurry to cure for at least 15-30 min. before applying second coat. Do not leave the first coat to dry longer than 8 hours. 
• For tile adhesive application on surface allow surface to cure for 3 days prior. 
• If first coat was cure over 8 hours, fix surface by applying 2 to 3 coats of Dr.Fixit Pidifin 2K for desire waterproof surface thickness or fix by applying Dr.Fixit Fevimate XL tile adhesive to act as top coat protection for Dr.Fixit Fastflex.

 Curing

• For maximum protection, allow 12 to 24 hours curing time after second coat. 
• Leave Dr. Fixit Fastflex at least 7 days to cure before filling or sealing water to test leaks.
  

• Non Flammable. 
• Avoid contact with skin and eyes. Any splashes to the skin or eyes should be washed off with clean water.
• Wear mask when mixing. 
• Wear protective gloves and eye protection when applied.