1. All Products
  2. AWAZEL PY 4180 L 4mm SBS Bitumen Membranes
Public Pricelist

AWAZEL PY 4180 L 4mm SBS Bitumen Membranes

https://sab-gate.com/web/image/product.template/1108/image_1920?unique=0269abf

Polymer (SBS) modified bituminous membrane Oxidized bituminous membrane,

147.00 AED 147.0 AED 147.00 AED

140.00 AED

    This combination does not exist.

      Terms and Conditions
    Prices excluding delivery costs
            

    Delivery with in 2 days
    Awazel SBS Membrane Awazel Membrane

    Related Blogs

    Awazel International Co.L.L.C.

    TDS

    Polymer membrane, reinforced with 180 g/m2 non- woven polyester mat. The polyester combines high tensile strength with an elongation above 50 %. (SBS) modified bituminous.

    To be successful your content needs to be useful to your readers.

    Used in one or two layers as tanking in basements or for waterproofing of roofs. A single layer followed by a layer of PY 40200LM can be used for exposed roofs.

    Used in one or two layers as tanking in basements or for waterproofing of roofs. A single layer followed by a layer of PY 40200LM can be used for exposed roofs.

    It is produced in rolls of 1 x 10 meters; The rolls are palletized and shrink-wrapped.

    The rolls should always be stored vertically in a shaded area. Normally the pallets should not be stacked one over the other. However, if a wooden board is used in between, two pallets may be stacked one over the other.

    The membrane fully bonded or loose-laid by torch welding. The substrate should be cleaned and primed with AWAZEL PRIMER D
    41and allowed to can be installed dry. Torching should be done by skilled labor and should be controlled so that only the PE film is melted and the asphalt coating is softened sufficient to bond the All lap membrane. joints smoothed and sealed using a heated round- nosed trowel. The heat of the gas flame should be applied to the trowel. In loose- should be.

    laid applications, only the lap joints, areas around penetrations (pipes etc.), Upstands and a 30 perimeter of the work should be fully
    bonded. Upstands and flashings should be installed using 1 M wide pieces cut from the length of the roll. (The overlap joints should be 5 to 10 cm at the sides and 15 cm at the cm wide strip around the end).

    New Products

    Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.