1. كافة المنتجات
  2. Polyurethane Foam Spray
  3. Asmaco PUF 40 Pre-Blended Spray Polyol
قائمة أسعار عامة

Asmaco PUF 40 Pre-Blended Spray Polyol

السابق صورة المنتج
صورة المنتج التالي
https://sab-gate.com/web/image/product.template/1701/image_1920?unique=624f1c1

220kg (BLUE) 250kg (RED)
is a pre-blended rigid polyurethane spray polyol designed for the insulation of roof,

5,019.00 ᴁ 5019.0 AED 5,019.00 ᴁ

4,780.00 ᴁ

    هذه التركيبة غير موجودة.

      الشروط والأحكام
    - Prices excluding delivery costs.
    - The above price may vary depending on the availability of raw material price, delivery and minimum order quantity.

            

    Asmaco PU Foam

    المدونات ذات الصلة

    Asmaco

    Silicone Sealants, Spray Paints, Adhesives, Tapes


    is a pre-blended rigid polyurethane spray polyol designed for the insulation of roof, wall and floor. 
    When
    reacted with ASMACO PUF MDI under the recommended reaction conditions, the foam has a good surface finish with excellent
    cell structure and good adhesion to various substrates.

    Polyol Component: mixture of base polyols, stabilizers, fire retardants, catalysts and blowing agent etc.
    Isocyanate Component: polymeric diphenylmethane diisocyanate.

    Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.

    In general, the following should be taken into consideration:

    • The system must be applied using plural-component spray equipment.
    • Component Temperature: 300C ― 50 0C depending on weather condition.
    • Component Pressure: 80 Bars ― 120 Bars.
    • Ambient Temperature: +10 0C ― +50 0C
    • Substrate Temperature: +10 0C ― +50 0C
    • Relative Humidity: <50 %
    • Wind speed: <20 km/h
    • The substrate must be clean, free from oil, dust, and moisture.
    • Pass thickness should not exceed 20 mm to maintain the designed density and dimensional stability.
    • Thick passes cause a decrease in density and reduce dimensional stability of the foam.
    • Very thin passes will increase the foam density and decrease product yield.
    • There must be a time gap of 5 ― 10 minutes before applying second layer.
    • Longer time gap is necessary for thicknesses above 100 mm.
    • Coverage and in-place density is dependent upon the temperature of the substrate, ambient air temperature, pass
      thickness, spray gun parameters etc

    Start with the customer – find out what they want and give it to them.

    منتجات جديدة

    Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.