Adesomode 1500 Self-Adhesive 4mm SBS Bitumen Membrane (-15c)

* Adesomode 1500 is a type of waterproofing membrane used in construction.
* It is self-adhesive, meaning it can stick to surfaces without the need for additional adhesives.
* The membrane is cold applied, which means it can be installed without the need for heat.
* It is made of SBS (styrene-butadiene-styrene) modified material, which provides flexibility and durability.
* The membrane has a polyester carrier, which provides additional strength and stability.
* The under layer of the membrane has a release film, which allows for easy installation and removal of the membrane.
* The upper surface of the membrane is covered with high density polyethylene, which provides protection against damage and weathering.

ADESOMODE 1500, a waterproofing material. The uses are as follows:

1. Waterproofing for raft foundation: A raft foundation is a type of foundation that spreads the load of a building over a large area. ADESOMODE 1500 can be used to waterproof the foundation, preventing water from seeping into the building.

2. Retaining walls: Retaining walls are structures that hold back soil or other materials. ADESOMODE 1500 can be used to waterproof these walls, preventing water from seeping through and causing damage.

3. Bathrooms, Kitchens, and wet areas waterproofing: ADESOMODE 1500 can be used to waterproof areas that are prone to moisture, such as bathrooms, kitchens, and other wet areas. This prevents water damage and helps to maintain the integrity of the building.

4. Base layer in a double layer roofing / waterproofing system applications: ADESOMODE 1500 can be used as a base layer in a double layer roofing or waterproofing system. This provides an extra layer of protection against water damage.

5. Waterproofing of roofs: ADESOMODE 1500 can be used to waterproof roofs, preventing water from seeping through and causing damage to the building.

Overall, ADESOMODE 1500 is a versatile waterproofing material that can be used in a variety of applications to prevent water damage and maintain the integrity of buildings.

instructions for the installation of Adesomode membranes for waterproofing purposes. 
The following are the detailed explanations of the instructions:

- Adesomode membranes should be installed fully bonded to the substrate. 
This means that the membrane should be securely attached to the surface it is being applied to.
While unloading the membranes from the truck, they should not be dropped or thrown down to avoid damage.
To prevent over-bending of the membrane at 90-degree corners, a 5 X 5 cm sand cement cant strip should be applied. 
This strip will help maintain the shape of the membrane at corners.
The surface to be waterproofed should be free from dust, oils, and should be smooth. 
This will ensure that the membrane adheres properly to the surface.
Before installing Adesomode membranes, the surface should be primed first with Nirol (W, WM, WB, R or S). 
Nirol is a type of primer that helps improve the adhesion of the membrane to the surface.
The position of each roll of membrane should be determined by unrolling it in its position, then rerolled about half of its length without changing its orientation. This will help ensure that the membrane is properly aligned before installation.
Each roll of membrane should overlap the next by 10 cm side lap and 15 cm staggered end laps. 
This will help ensure that there are no gaps between the rolls of membrane.
For sloping roofs, the membrane should be laid from the lower edge with longitudinal directions of rolls perpendicular to slap direction. 
The side laps of the next roll should be placed above the first one, and so on. 
This will help ensure that the membrane is properly aligned and that water does not seep through.

TDS